Position Description
- Must pass a drug test and a background check.
- Typical start time is 5:00 AM, however hours vary as requested by the owner or general contractor of each work site.
- Primary duty is to install cabinets and trim on the jobsite.
- Must be familiar with the use and care of power and hand tools that are required in a cabinet shop.
- May be required to work with other carpenters or helpers on projects and be able to oversee the quality and keep the others productive while on that project.
- Position requires ability to work with lumber, veneer, and sheet goods as well as plastic laminate.
- May assist in keeping shop area clean.
- Requires some heavy lifting.
- Requires wearing a hard hat and safety glasses that will be provided to you by Contemporary Cabinets.
Experience
- A minimum of 5 years installation experience of commercial millwork or high end residential cabinets and trim.
Tools
- Pencil
- Tape measure
- Air nozzle
- Magnet tip holder (Apex)
- Putty knife
- Pair of adjustable wrenches (Crescent)
- Finish hammer
- Pliers (Adjustable)
- Screw driver set
- Awl
- Bullnose dikes
- Chisel set
- Nail set
- Pliers (Channel lock)
- Pry bar / Flat bar / Wonder bar
- Tri square / Combination square
- Allen wrench set
- Brush/Foxtail
- Cordless drill
- Dead blow mallet
- Drill bit set
- Framing square
- 2 – 4 Locking c-clamps w/ swivel pads (snappys)
- Pliers (needle nose)
- Scale ruler
- Scribe / compass
- Speed square
- Stud finder / magnet
- Tool / nail bag
- Torpedo level
- Utility knife
- Vix bit set
- Steel toed boots